Matrix SATATYA NVR Quick Start 53
LAN 2 option will be visible as per your NVR/NVRX variant.
Storage
You can configure the volume for the storage in NVR. It supports different RAID levels for storing
the data in multiple physical disks interfaced with the NVR.
RAID level is used to improve the performance of the system by load sharing and providing fault
tolerance and redundancy. This maintains redundant data which can be used to restore data on
the event of disk failure.
SATATYA NVR Series variants support RAID 0, RAID 1, RAID 5 and RAID 10 HDD modes.
Among all the NVRX/NVRX P2 variants, there is difference in number of available SATA interfaces
and Ethernet ports. So based on SATA interfaces, RAID level can be configured.
For the detailed explanations of supported RAID types and to know more about RAID creation and
Total Logical Volume in different NVRX/NVRX P2 series variants, refer the Raid Concept in the
Matrix SATATYA System Manual.
Storage page appears on the screen as No Disk Found if the Hard Disks (HDD) are not connected
with the device.
Once the HDDs are connected you can configure the storage for your NVR as follows:
To Next Page
Loading...
Need help?
General
