What should I do if my Matrix T1xe-02(AC) shows 'Over / low DC bus voltage'?
If your Matrix Treadmill displays 'Over / low DC bus voltage', use a multi-meter to check if the input power is over 260V. If the power outlet is OK, replace the MCB.
What should I do if my Matrix T1xe-02(AC) Treadmill displays 'MCB over temperature'?
If your Matrix Treadmill displays 'MCB over temperature', check the condition and connection of the motor cable at the MCB. Use a multi-meter to check the motor cable for resistance at the 2 blue wires in the cable. If the blue wires of the motor cable display an ohm value, replace the motor. If the blue wires of the motor cable do not display an ohm value, replace the MCB.
What to do if Matrix T1xe-02(AC) Treadmill displays 'No communication response'?
If your Matrix Treadmill displays an 04A0 error, check if the MCB Com LED is lit. If the MCB Com LED is not lit, check the connection of the digital communication wire at the MCB. Replace the digital communication wire. Replace the console. Replace the MCB.
Provides initial safety advice and operational guidelines before using the treadmill.
Details critical safety warnings, precautions, and proper usage guidelines for the treadmill.
Outlines the necessary electrical specifications and dedicated circuit requirements for safe operation.
Provides detailed procedures and schedules for daily, monthly, and quarterly equipment maintenance.
Guides users through the automatic calibration process for incline and other electronic components.
Explains how to properly tension and center the running belt for optimal performance and safety.
Details indicators and methods to determine if the running belt and deck require replacement.
Lists common error codes displayed on the console and their conditions.
Guides troubleshooting for incline motor failures and disconnections.
Addresses main motor U, V, and W phase disconnection errors.
Step-by-step instructions for removing and reinstalling the treadmill motor cover.
Guides on how to replace the rear roller assembly of the treadmill.
Provides instructions for removing and installing a new running deck.
Explains the procedure for replacing the treadmill's front roller.
Step-by-step guide for replacing the treadmill's running belt.
Guides on how to replace the Motor Control Board (MCB).
Provides detailed instructions for replacing the main treadmill motor.
Explains the procedure for replacing the drive belt of the treadmill.
Step-by-step guide for removing and replacing the incline motor.
Instructions for removing and installing the treadmill console.
Details how to replace the emergency stop button assembly.
Outlines the final checks and tests after installation or part replacement.
To Next Page
General
