13
1. To enter Engineering Mode, hold the INCLINE DOWN and SPEED DOWN keys for three seconds until Manager Mode appears on the middle LED dis-
play.
2. Press any UP arrow key and Engineering Mode will appear on the display.
3. Press ENTER once Engineering Mode is displayed.
4. To scroll between programs in the Engineering Mode, press any UP or DOWN arrow key.
5. Press ENTER to modify the program settings once displayed.
6. Press any UP or DOWN arrow key to change value.
7. Once program setting is correct, press ENTER to save.
8. Press the EMERGENCY STOP to exit Engineering Mode.
6.1 USING ENGINEERING MODE
CUSTOM SETTING DEFAULT MINIMUM MAXIMUM UNIT DESCRIPTION
Disable Errors ON ON OFF N/A Resets error log.
Accomplished by pressing
INCLINE DOWN and SPEED
DOWN for 3-5 seconds.
Elevation Minimum 28 20 239 N/A Controls the low incline
parameter.
Elevation Maximum 230 20 239 N/A Controls the high incline
parameter.
Auto Calibration N/A N/A N/A N/A This function is to calibrate the
treadmill incline.
Speed Units MILE MILE KILOMETER DISTANCE Measurement unit used for
calorie calculations, distance,
and speed.
Pause Time 30 SECONDS 5 SECONDS 10 MINUTES SECOND / MINUTE Controls the maximum time the
treadmill can be paused during
a workout.
Machine Type N/A N/A N/A N/A Sets the machine ID, not
editable.
RPM Parameter 2055 100 3000 N/A Checks and adjusts the low
speed.
6.2 ENGINEERING MODE OVERVIEW
CHAPTER 6: ENGINEERING MODE
To Next Page
Loading...
