Matrix T5X-04 - 9.3 Deck Replacement

34
9.3 DECK REPLACEMENT
1) Remove the motor cover as outlined in Section 9.1.
2) Remove the rear roller as outlined in Section 9.2.
3) Remove the four deck screws using a 5 mm Allen wrench (Figure A).
4) Remove the deck from the running belt (Figures B & C).
5) Reverse Steps 1-4 to install a new running deck. NOTE: The running deck is waxed on both sides so the opposite side surface may be
usable. New running deck surfaces must ALWAYS be matched to a new running belt.
6) Tension the running belt as outlined in Section 3.5.
FIGURE A
FIGURE B FIGURE C
CHAPTER 9: PART REPLACEMENT GUIDE