33
1) Remove the shrouds as outlined in Section 8.11.
2) Remove the 3 screws holding the cover onto the lower board and remove the cover (Figure A).
3) Disconnect the 3 wire connections to the lower board (Figure B).
4) Remove the 2 screws holding the lower board to the frame (Figure C), and remove the lower board.
5) Reverse Steps 1-4 to install a new lower board.
6) Test the bike for function as outlined in Section 8.20.
8.12 LOWER CONTROL BOARD REPLACEMENT
CHAPTER 8: PART REPLACEMENT GUIDE
FIGURE A FIGURE B
FIGURE C
To Next Page
Loading...
