CD 30 ÷ 520
59
invalid. On the other hand, if there are some units running (including manual/auto state),
pressing ON/OFF means OFF, and Mode, Manual/Auto, Address Up/Down buttons are
invalid; if unit is off, pressing ON/OFF means ON, and Mode, Manual/Auto, Address
Up/Down buttons are valid.
After turning off unit by Pressing ON/OFF, all of running information will be preserved in
next start (including Mode and Manual/Auto state).
ON/OFF is valid for any state, but it will not work if you re-press the ON/OFF when the
information of last operation is being conveyed, you have to wait for not more than 5
seconds to re-operate.
9——Lock.
If wire controller is not locked by net compute, pressing Lock for more than 5 seconds,
buttons will shift from the unlock to lock or vice verse.
If wire controller is locked by net compute, pressing Lock, Manual/Auto and Mode
simultaneously for more than 10 seconds, the controller will be unlocked and buttons
will be unlocked as well if they were locked before.
If wire controller or buttons are locked, all buttons except the buttons about unlocking
operation (Lock, Manual/Auto and Mode) are invalid.
3. Basic operating conditions
Voltage input: single phase 198V -- 242V
Frequency: 50Hz
Ambient Temp. :-15ć+43ć
Ambient humidity: RH40%-RH90%
4. Functions description
1——Electrify/Reset
After electrifying or resetting wire controller, firstly, all the display segments on the crystal
display will be on for 2 seconds and off for 1 second, then work normally. Wire controller enters
default page: Mode setting page. Default setting is: Cooling, Auto, On, and the flashing
indicator lights with waiting mode. If there is no operation for 8 seconds, it will quit from waiting
To Next Page
Loading...
