CD 30 ÷ 520
28
10. Unit installation
Transportation
Be sure that the package will be transported safely, unpack until arrive at installation site
The leaning angle during the transportation should be smaller than 15 degree to prevent
the module from rolling over.
When transporting the module with rolling bars, it is recommended to use 6 bars under the
module, each one should be a bit longer than the width of basement to keep the module’s
in balance.
Sling the module with steel wire, be sure that the wire could bear the weight 3 times
heavier than that of the module, and Query whether if it hooks to module tightly. The
hanging angle should be bigger than 60 degrees.
Notice: it is absolutely forbidden to stand under the module while hanging, please use soft
board to protect the module surface which contact the steel wire from scratch and
distortion.
Protect Board
To Next Page
Loading...
