Maxon GPT-4 - Loading and Unloading Platform

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
17
3. Run Control Switch cable under Vehicle Body
(see dashed line in FIG. 17-1A) and through
the Grommet on the Pump Box. Use 2 loom
clamps and 2 self-tapping screws (Parts Box)
to secure the Control Switch cable to vehicle
frame.
STEP 6 - INSTALL CONTROL SWITCH - Continued
PLATFORM
(OPEN AND RAISED)
3/4” HOLE
VEHICLE BODY
VERTICAL POST
CONTROL SWITCH
CABLE
GROMMET
PUMP BOX
ROUTING CONTROL SWITCH WIRING
FIG. 17-1A
2. Route the Control Switch cable through the
¾” hole in the Vertical Post (FIGS. 17-1B)
and down the Vertical Post as shown in
(see dashed line in FIG. 17-1A). When
the Control Switch is close to the Post,
attach Control Switch to Vertical Post with
2 self-tapping screws (FIG. 17-1B).
SELF-TAPPING
SCREW
CONTROL SWITCH
DECAL
(SEE DECALS PAGE)
ATTACHING CONTROL SWITCH
FIG. 17-1B
3/4” HOLE