Maxon GPT-4 - Step 12 - Check Hydraulic Fluid

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
26
TABLE 26-1
TABLE 26-2
LIOCILUARDYH51OSI
SDNARBDEDNEMMOCERREBMUNTRAP
LIOSMA50-FWA
NORVEHC51-VM-WA,ADIULF
LLADNEKULBLAICALG
LLEHS51-TSULLET
NOXXE31-IVHSIVINU
LIBOMM11-ETD
LIOCILUARDYH23OSI
SDNARBDEDNEMMOCERREBMUNTRAP
LIOSMA50-HWA
NORVEHC23NYSREPIH
LLADNEKVMNEDLOG
LLEHS23-TSULLET
NOXXE23-NSIVINU
LIBOM
,42-ETD,M31-ETD
31-LIOCILUAR
DYH
DIULFCILUARDYH6065-H-LIMRO01-OSI
SDNARBDEDNEMMOCERREBMUNTRAP
LIOSMAA/N
NORVEHCGDIULF,ADIULF
LLADNEKULBLAICALG
LLEHS14-DIULFLLEHSOREA
NOXXE31-IVHSIVINU
LIBOMAFHOREA
TABLE 26-3
+70 to +140 Degrees F - Grade ISO 32
+40 to +105 Degrees F - Grade ISO 15
Below + 70 Degrees F - Grade ISO 10 or MIL-H-5606
NOTE: Use correct grade of hydraulic fluid for your location.
See TABLES 26-1, 26-2, & 26-3 for recommended brands.
STEP 12 - CHECK HYDRAULIC FLUID
1. Remove the Filler Cap (FIG. 26-1).
CHECKING HYDRAULIC
FLUID LEVEL
FIG. 26-1
2. Check the Hydraulic Fluid level in the
Pump Reservoir (FIG. 26-1). If fluid is
below FILL LEVEL shown on Decal
on the Pump Reservoir (FIG. 26-1),
add fluid to the FILL LEVEL.
3. Reinstall the Filler Cap (FIG. 26-1).
PUMP
RESERVOIR
FILLER
CAP
DECAL
(FLUID LEVEL)