Intelimax+4G User Manual
- 15 -
Serial Port Connection
Use this section to connect to the modem using the provided RJ45 power/serial cable,
the default connection settings are:
Baud Rate: 115200
Data Bits: 8
Parity: None
Stop bit: 1 bit
Flow control: None
Make sure to select the correct COM port and click the open button, the Intelimax+ GUI
will connect to the modem via the selected COM port. The GUI can also perform a
search for the correct baud rate if it is not known.
The configuration operations available over a serial connection to the modem are
limited when compared to a TCP/IP connection.
To Next Page
Loading...