Intelimax+4G User Manual
- 30 -
•
Server mode: In Server mode the modem will connect to a PPP session and will
listen on a predefined port for incoming client requests
•
Client mode: the modem will initiate a PPP connection and try to connect to the
Primary server. If the connection to the server fails 10 times it will try the Secondary
server, if the connection to the secondary server also fails for 10 times the modem
will drop the PPP connection, reboot and start all over again.
Manual Auto Reconnect Client
Define whether the modem will automatically try to reconnect to TCP server if the socket
connection is dropped externally.
The Auto reconnection will be disabled if a socket disconnection command
(AT$$IPCTCS) is received from Serial Port.
Primary Server
Define the IP Address or DNS address of the primary server the Intelimax+ will try to
connect to in Client mode, in server mode please leave this field as default.
Secondary Server
Define the IP Address or DNS name of the secondary server the Intelimax+ will try to
connect to in Client mode, in server mode please leave this field as default.
Port Number
Define the TCP or UDP Port number, this port will be used in the server and client mode.
IP STACK Notifications
IP Stack notifications are by default sent out on the serial port to the connected host.
With some applications this may cause issues with data transfer and using this option the
user can disable or enable the notification messages.
TCP Session Control
Idle Timeout / Idle Timer: Enabling the idle Timeout and setting an Idle Timer, will set the
Intelimax+ to disconnect from a connected server (if configured as a client) or the
connection from a connected client (if configured as a server) if the modem receives no
To Next Page
Loading...