Intelimax+4G User Manual
- 59 -
Remote Mode Change via CSD Call
The Intelimax+ has the unique in-built feature of being able to change between modes
and configure settings remotely over a CSD call. This is especially useful if you have a
modem in the field that you need to remotely configure using remote AT commands or
the Intelimax+ GUI but are currently using CSD to talk to this modem. Using these
commands lets you change to an IP connection for easy access to the device over an IP
connection.
It is very important to ensure that you can access your modem once this is done which
means either using a static IP address (private IP WAN or similar) or a public dynamic IP
address such as telstra.extranet the WAN IP of which can be found via SMS.
Dialling Process
Dial out to the modem via a command line terminal session to your data modem using
the data number of the SIM card in the Intelimax+. The sting will be as follows:
ATDT0400123456. Once the ‘CONNECT’ message has been displayed you are
connected.
Intelimax+ Remote Configuration Commands
The following commands can be used to change the settings of the Intelimax+:
Unlock the CSD programming interface:
program.maxon.unlock=admin:admin
admin:admin are the default username and password, if you have changed
these update this command with the appropriate values in the order
username:password.
Update the cellular APN:
program.maxon.apn=telstra.extranet
Update the username, password and authentication:
program.maxon.auth=userid:password:chap/pap/none
Change the mode of the modem:
program.maxon.mode=1 Where:
1 - IP Stack Auto mode – auto connect IP
2 - IP Stack Manual mode – manual connect IP
To Next Page
Loading...