Intelimax+4G User Manual
- 14 -
Connecting to the Intelimax+4G
TCP/IP Connection - Recommended
Using the TCP/IP connection option allows users to connect to the modem via an IP
connection. Firmware upgrades can ONLY be done when connected via TCP/IP.
Local Connection
To use this feature locally you must follow the following steps:
1.
Plug in modem RJ45 power/serial cable then mini USB cable in this order
2.
Install USB/LAN drivers which can be downloaded from:
http://www.maxon.com.au/product-supports/drivers-and-manuals.html
3.
Set a static IP address to the modem:
Once the drivers are installed you will have to set a static IP on the Intelimax+
network connection (as the Intelimax+ does not support DHCP)
4.
The default IP for the Intelimax+ is 192.168.10.1, set your IP within this range
Eg.192.168.10.50
5.
Connect the GUI to the modem after modem has booted (1-2 minutes after
powered)
The default settings are: Address: 192.168.10.1 (Intelimax+ LAN IP address), Port:
10918, ID: admin, Password: admin. The password has to be re-entered when
opening the GUI each time.
Note: If all modem settings are not loaded into the GUI after connection, click the ‘Load
from Modem’ button at the bottom to refresh the settings.
Remote Connection
Users can also access the Intelimax+ remotely via a static IP address (e.g. maXwan) or
via a url (e.g. DynDNS):
To Next Page
Loading...