Intelimax+4G User Manual
- 52 -
Other GUI functions
Output Info
•
Output Information for receiving Intelimax+’s data in serial or remote access.
•
When syslog is requested, this is where they are printed before being saved to a
file.
Clear Output
Clear all information in the ‘Output Info’ window.
Save Output
Save Output Info information to a .txt file.
IP Stack Functions
These options are available when connected to the modem via serial.
IP Stack Connect Button
When IP Stack is Manual Mode, connect without AT Command input. Sends the
appropriate AT command (‘AT$$IPCTOS’) to the modem via the serial port.
IP Stack Disconnect Button
When IP Stack is Manual Mode, disconnect without AT Command input. Sends the
appropriate AT command (‘AT$$IPCTCS’) to the modem via the serial port.
Send CR, LF
Add Carriage Return and Line Feed message when data is sent. Use for AT Command
sending via the GUI. It is recommended that this check box is used as it emulates pressing
the ‘Enter’ key on your keyboard.
Send Button
Send AT Command and Data.
To Next Page
Loading...