Intelimax+4G User Manual
- 91 -
EXTE N D ED /MODEM SPECIFI C AT CO MMAND
SET (IP and SERIAL MODES)
Save settings and reset/restart modem
AT&W (Serial and IP Stack modes)
Saves AT command settings
AT%RESET=1 (Serial Modem mode only)
AT$$RESET (Serial and IP Stack modes)
Applies saved AT commands with a reboot
Standard AT Commands for serial interface
Note.1 : [ ] indicates default value.
Note.2 : &D option only valid when Serial Port is using no flow control. DTR signal will be
used together with CTS/RTS as Hardware Flow Control signals.
SMS Commands
Do not echo command set in command state or online command
state.
Echo command set in command state or online command state.
Do not return result codes.
DCD line is ON during a circuit switched call. In IP Stack mode, the
behaviour is the same as &C0.
DCD line is normally ON and will toggle OFF for 1 second when the
circuit switched call is disconnected. In IP Stack mode, DCD line will be
always OFF.
DCD line is normally OFF and will be ON when modem has successfully
established a PPP Data (packet switched) call (only applies to IP STACK
mode). In Serial Modem mode, DCD line will be always OFF.
DCD line is normally OFF and will be ON when modem has successfully
established a PPP Data and opened a socket with remote server (only
applies to IP STACK mode). In Serial Modem mode, DCD line will be
always OFF.
Enter online command state following ON-to-OFF transition of DTR line
while retaining the data connection.
Disconnect the data connection following ON-to-OFF transition and
change to command state after back to ON state. In Serial Modem
Mode, during OFF state of the DTR line, the auto-answer function (see
S0) is disabled. During the transition, DTR line has to be in OFF state for
at least one second for the modem to respond.
Automatic answering. [Enable automatic answering
after (Value) x 6 seconds.]
0: No auto- answering
To Next Page
Loading...