Maxon Intelimax+4G - Telnet; SSH Commands; Connecting via Telnet

Intelimax+4G User Manual
- 64 -
TELN E T / S SH C O M MAND S
Using Intelimax+ Telnet / SSH commands allows you to configure the modem remotely,
also you can send diagnostic commands here is summary off of tasks that you can
perform
1. Stat : Used to display sys log, system info and DNS settings
2. Setup: using this menu you can setup system settings, Dynamic DNS, operation
mode, SNMP and SNTP settings
3. Send Direct AT commands to the modem module
4. Check signal strength t+
5. Use Ping command
6. Check system up time
7. Set the modem to factory default
8. Reboot the modem
Connecting to the modem via telnet
To access the modem via Telnet or SSH you will need the following
1. A Telnet or terminal software you can use windows telnet
2. Telnet needs to be enabled on the Intelimax+
3. Modem IP Address or Dynamic DNS URL
4. Modem Username and Password
Connection Steps
1. Run your telnet software and put the modem IP address or URL
2. Enter your username and password
3. Type help to display all available configuration commands
Screen Shoots below show the different telnet Commands:
Once you log in to telnet. You can choose whether to start telnet service, set up