Maxon Intelimax+4G - Extended AT Command Set: IP Stack Modes; Device Information Commands

Intelimax+4G User Manual
- 76 -
EXTE N D ED /INTELIM AX + SPECIFI C AT
COMMAND SET (IP STACK MODES)
Device Information
ATI
Manufacturer: Maxon Australia Pty
Ltd Model Number: MA-2020
Product Name: Intelimax+
F/W Revision: 0.0.0 [201201130929]
H/W Version: 1.0
Module F/W Revision:
11.810.09.05.00 LAI: 50506
LAC: 4eeb
CellID:
00cb63b3
IMEI:
354283040117446 OK
AT+CGMI
Maxon Australia Pty Ltd
AT+CGMR – Firmware version
+CGMR: 2.0.8 [201409230653]
AT+CGSN – IMEI number
354283049080793
AT Command Password Protection
This AT command process will protect the changing or monitoring of any AT command
unless the interface password is entered first. Once enabled, any AT command will return
an ERROR response.
AT$$SERIALPWD=<0,1>,<PWD> - disable, enable and set password
Once the command has been entered, a save (AT&W) and reboot (AT$$RESET) is
required. To disable the password protection for a session, enter the following, this will
persist until the modem reboots:
AT$$PWD=<PWD>
WAN Extension Functions