Maxon Intelimax+4G - AT Command Parameters: WAN Settings

Intelimax+4G User Manual
- 77 -
AT$$WANSE?
$$WANSE:
PINGCHECK:Enable,0,0,0.0.0.0,
BACKOFF:Disable,0,0,0,0
OK
Parameters
$$WANSE: X,X,X,X,X,X
0,1 PINGCHECK,BACKOFF
0,1 Disable/Enable both expansion PINGCHECK and BACKOFF
1~60 PINGCHECK Interval (seconds) / 40~59 Seconds of 1st retrial interval of BACKOFF
1~60 PINGCHECK Fail count / 2~10 Minutes of 1st retrial duration of BACKOFF
IP address of 1st server for PINGCHECK / 10~59 Minutes of 2nd retrial interval of BACKOFF
IP address of 2nd server for PINGCHECK / 2~10 Hours of 2nd retrial duration of BACKOFF
OK
WAN Authentication
AT$$WANSA?
$$WANSA: 1,telstra.extranet,0,,,*99#,0,,0,0,0,0,00:00,0
OK
Parameters
$$WANSA: X,X,X,X,X,X,X,X,X,X,X,X,X,X,X,X
1,2 IPStack Auto/Manual
Access Point Domain Name
0,1,2 NONE/PAP/CHAP
Username
Password
Dialup number
0,1 Auto PIN Disable/Enable
PIN code
0 ~ 28 Hours of Periodic reset
0,1 Disable/Enable Reset (TCP Server Listening) – Server – If enabled will wait until client
drops connection
0,1 Disable/Enable Reset (TCP Connected State) – Client – If enabled will wait until
Intelimax+ client drops connection to a server or server drops connection
0,1 Disable/Enable Reset (At scheduled Time) HH:MM
for Reset (At scheduled Time, 24 hour format)