Intelimax+4G User Manual
- 29 -
the following process:
1.
Create the certification file for upload to the Intelimax+. The certificate files
should be placed into a folder along with a path.txt file.
2.
The path .txt file should only contain the text “extra”.
3.
Zip this folder, then upload to the Intelimax+ using the ‘Partial upload’ button in
the GUI, then reboot the modem.
4.
Once the modem has rebooted the uploaded certificates can be seen on the
status page under the ‘Extra’ section.
Note: To remove the certificates, upload a .zip file with one file, a path.txt file with the
text “-extra”.
Note: If both SSLv3 IP Stack and secure syslog is used at the same time then the same
private key and certificate are used (the ca.pem certification file is not used by SSLv3).
How to generate SSL certificates
A SSL certificate can be generated using an application such as OpenSSL
(http://slproweb.com/products/Win32OpenSSL.html, the lite version is fine). To generate
certificate for client and key for client (key.pem, cert.pem):
C:\OpenSSL-Win32\bin>openssl req -new -x509 -days 3650 -nodes -config openssl.cfg -
out cert.pem -keyout key.pem
This application can be run from the command line for example: C:\OpenSSL-
Win32\bin>openssl req -new -x509 -days 365 -nodes -config openssl.cfg -out cert.pem -
keyout key.pem.
The resultant 2 certificate files contained in the /bin folder and are named: cert.pem and
key.pem.
IP Stack Modes
Intelimax+ supports operation of the IP Stack in either client or server modes:
To Next Page
Loading...