Maxon Intelimax+4G - Serial Password and Boot Up Message

Intelimax+4G User Manual
- 27 -
depends on the equipment requirements and settings.
Other modem related settings include:
&D, S0, &C, Echo, and Q
Serial Password – Password protected AT commands
The Intelimax+ has the ability to password protect serial interface AT commands. The
serial password can be set on the serial tab. If AT commands need to be entered then
AT commands will return an ERROR message until the interface password is entered first
with the command, AT$$PWD=<password>. Once the password is entered the access
will persist for the session until the modem reboots. Further AT command detail in the AT
Command Password Protection section under the Intelimax+ specific AT Commands
section.
Boot up Message
The Intelimax+ boot up message “INTELIMAX READY” is a message that the modem
sends to the host via serial port upon boot up after a hardware power restart event.
Using this option the user can disable or enable this message.