Intelimax+4G User Manual
- 81 -
maXconnect
To enable maXconnect on the Intelimax+ either use the GUI or enter the following
commands when the modem is in IP Stack Auto mode.
$$MAXCNT: 0,120,portal.maxconnect.com.au,1883,updates.maxconnect.com.au
OK
AT$$MAXCNT=?
$$MAXCNT: X,X,X,X,X
0,1 Disable/Enable
Refresh Interval
Broker URL
Broker Port
FTP update server URL
OK
Serial Port settings
Serial port settings including number of data bits, parity, and stop bits must be set using
this command, but other commands can also be set using standard AT commands
such as AT+IPR, AT+IFC etc.
AT$$SPORT?
$$SPORT: 115200,8,N,1,None,0,0
OK
Parameters
$$SPORT: X,X,X,X,X,X,X
1200,2400,4800,9600,19200,38400,57600,115200 Baud rate
7,8 Data bits
N,E,O None/Even/Odd
1,2 Stop bits
None, Software, Hardware Flow control
0 Don’t Care
0,1,2 RS232, RS485FullDuplex, RS485HalfDuplex
OK
Cellular Band selection
To Next Page
Loading...