Warning:
◎ Refrain from installing or ceasing the laser head while it is active. To perform these actions,
always verify that the switch is in the "off" position and that the device is unplugged from AC
power.
8. Equipment and solvents
Warning:
◎Please note that the photosensitive components within the equipment, including
the camera, photomultiplier tube, and photodiode, may suffer damage from laser
exposure. The laser has the capacity to inflict burns on skin, clothing, and paint. It
possesses the potential to cut and weld metal. Additionally, the laser can ignite
volatile substances like alcohol, gasoline, ether, and other solvents. Ensure to
take necessary precautions and avoid exposure to solvents or flammable
materials and gases during the installation and operation of the equipment.
9. Electrical safety
Warning:
◎ Ensure that all electrical and welding gas connections are properly connected
and secured with screws, if necessary, before powering the unit. The input voltage
to the laser can be lethal, and all cables, connectors, and equipment enclosures
should be treated as hazardous.
◎ Prioritize electrical safety by properly grounding the equipment through the
protective conductor of the AC power cable and protecting the ground terminal. Any
interruption could potentially cause personal injury.
◎ Before providing power to the equipment, ensure the correct AC supply voltage is
used to avoid damaging the device. Refer to the markings on your specific model for
To Next Page
Loading...
Need help?
General
