NOTICE:
◎
Before using this product, please check the cleanliness and integrity of the
protective lens. Operating with a dusty or damaged protective lens may cause
damage to the welding torch head (focusing lens, extension tube, etc.) and affect
welding quality.
◎Unauthorized disassembly of the gun head and laser products will void the
Maxphotonics warranty.
◎ Please wear powder-free gloves or finger cots when cleaning the product in a dust-
free environment. Maxphotonics is not responsible for tip damage due to improper
operation or incorrect cleaning procedures.
◎
When cleaning, the concentration of alcohol should be greater than 99.5%.
2.Cleaning Steps Follow these procedures to clean and maintain the laser welding
machine:
(1) Turn off the laser switch and disconnect the power supply;
(2) Rotate the locking screw on the protective mirror housing from the gun head
and pull out the mirror holder (sealed with clean masking tape to prevent dust from
entering). Use an optical cleaning cloth dipped in alcohol to wipe the entire
protective mirror window surface;
(3) Hold the window in the left hand and place it under the microscope (20x
magnification);
(4) With the right hand, adjust the focal length of the microscope so that the
protective lens surface is clearly visible;
(5) Carefully examine the protective lens surface. If dust or tiny particles are
present, use a cotton swab to clean them:
① Dampen a cotton swab with alcohol, shaking off any excess;
② Position the cotton swab on the dust location on the lens under the microscope;
③ Gently wipe the dust with the swab, moving it towards the edge of the lens, and
replace the swab after use;
④ After cleaning all debris, verify cleanliness under the microscope.
To Next Page
Loading...
Need help?
General
