MAXPhotonics MA1 Series User Manual

(6) Insert the cleaned protective lens into the lens holder;
(7) Place the protective lens holder into the gun head's lens cavity seat and fasten
the locking screw on the lens holder shell to secure the lens holder in place..
IMPORTANT:
◎ Do not reuse lint-free cotton cloth or cotton swabs..
◎
Do not touch the welding torch head's protective lens with your fingers.
◎ Do not blow directly on the lens surface with your mouth as this may introduce new debris.
◎ Do not touch the cleaning swab's tip with your fingers..
◎
Remember to clean the protective cover and sleeve when replacing them.
◎
When using compressed air, avoid blowing debris directly at the surface, and
instead use a side-blowing technique.
◎ If the protective lens holder cannot be immediately reinstalled, seal the lens cavity
shell with textured paper
69

MAXPhotonics MA1 Series Specifications

General

Brand	MAXPhotonics
Model	MA1 Series
Category	Welding System
Language	English