13
Chapter 2 General Safety Information
and contact Maxphotonics.
3
、
Ensure that the work surface is properly vented. There may be gases, sparks
and debris generated from the interaction between the laser and the work
surface, and they could pose additional safety hazard.
CAUTION :
◎
The device may be damaged with incautious operation.
◎
If the laser is placed in an environment below 0°C, be sure to add a
corresponding antifreeze to the water tank of the chiller. If the machine is not
used for a long time, be sure to drain the water in the inlet and outlet channels
(high-pressure air gun is recommended) to prevent the residual water from
freezing and damaging the water-passing devices.
To Next Page
Loading...
