35
Chapter 7
Fiber Connector Inspection and
Cleaning Guide
1-Notice
It is imperative that the fiber connector is checked for dust, dirt, or damage
every time it is connected to any optical device, before use. The use of a
dirty or damaged fiber connector can result in serious injury and/or laser
damage. Maxphotonics is not responsible for any damage due to contaminated
connectors.
For cleaning a fiber connector, you need the following materials:
1
、
Powder-free rubber gloves or ngerstall
2
、
Lint free optical cleaning wipes and/or swabs
3
、
Ahydrous ethanol (Optical level, pure >99.5%)
4
、
Acetone (Optical level, pure >99.5%)
5
、
Compressed air (oil free, water free)
6
、
Microscope
7
、
Light source
IMPORTANT :
◎
It is imperative that you wear powder-free rubber gloves during this cleaning
procedure! It is hereby stated that damage to the fiber connector can occur
due to mishandling, the use of incorrect cleaning procedures, or chemicals for
cleaning. This is not covered by the Maxphotonics' warranty. Ahydrous ethanol
and acetone should be managed and stored according to the local law and
To Next Page
Loading...
