7
Chapter 2 General Safety Information
2-Laser Protection
1
、
Laser Protection Requirements
You must wear the safety protective glasses while operating the laser, and
rationally select the safety protective glasses according to the lasing wavelength
of the laser. If the device is a tunable laser or Raman product, it emits light
over a range of wavelengths and the end user should conrm the laser safety
eyewear used protects against light emitted by the device over its entire range
of wavelength.
2
、
Laser Protective Equipment Suppliers
Maxphotonics recommends material or equipments provided by following laser
protective equipment suppliers for you, including LaserVision USA, Kentek
Corporation, Rochwell Laser Industries, etc. All the supplier information is
provided by Maxphotonics only for the convenience to use, so Maxphotonics
assumes no responsibility for any problem caused by using the products of
abovementioned suppliers.
NOTE :
◎
Maxphotonics' MFSC 3000W (Chassis Type) Single Module CW Fiber Laser .
It may emit up to 3000W average power from 1060nm to 1100nm. This level
of light may cause damage to the eye and skin. Despite the radiation being
invisible, the beam may cause irreversible damage to the retina. Laser safety
eyewear is not provided with this instrument, but must be worn at all times while
the laser is operational.
To Next Page
Loading...
Need help?
General
