CAUTION:
Prior to engaging in any cleaning, maintenance, or repair work, it is crucial to disconnect the exerciser
completely from the power supply. This can be achieved by disconnecting the mains cable both from
the power socket and from the training device.
Therefore, first disconnect the electrical plug from the power socket, and then disconnect the mains cable
from the exerciser. The mains cable may only be reconnected to the training device and the power supply
when all work has been completed and the proper functional condition of the device has been restored.
Cleaning
Clean your training device after each workout using a damp cloth and soap. Avoid using solvents as they may
cause damage. Regular cleaning is vital for preserving and prolonging the life of your training device. Body
sweat contains chemicals that can lead to corrosion (rust) if not promptly removed. Therefore, after every
training session, check if body perspiration or other fluids have come into contact with the device. If this is
the case, clean the affected components and housing parts.
Please note that damages caused by body sweat or any other liquids are not covered by the warranty.
During training, ensure that no fluids can enter the training device or the computer.
Maintenance
Checking the Fastenings
Regularly check the tightness of nuts and bolts, at least once a month, and re-tighten as necessary.
Lubricating the Sliding Tubes
Clean the top of the sliding tubes regularly using a damp cloth and mild liquid hand soap or detergent. For
professional cleaning, MAXXUS® Degreaser Spray is recommended. Ensure the sliding tubes are thoroughly
dried, then apply a thin layer of liquid silicone or MAXXUS® lubricant spray to the top of the tubes.
For frequent use, clean and lubricate the sliding tubes once a week. If squeaking sounds occur during training,
lubricate the sliding tubes immediately. Care and cleaning agents are available for purchase on our online
shop at www.maxxus.com.
Lubricating the Axles on the Handlebar Stem and Drive Discs
Every 6 months, it is recommended to lubricate the two transverse axles on the handlebar stem and the axles
on the large drive discs using multipurpose grease.
Care, Cleaning & Maintenance
14
To Next Page
Loading...
Need help?
General
