EasyManuals Logo

Maxxus CX 5.1 User Manual

Maxxus CX 5.1
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
My training device makes noises during training – is this normal?
Your MAXXUS® training device is designed with high-quality ball bearings and a grooved belt, along with
a premium magnetic braking system that is entirely wear and friction-free. These exceptional components
significantly reduce functional noises, making your MAXXUS® training device one of the quietest products
available in the fitness market. However, it is normal to experience slight mechanical noises during training.
These noises can occur continuously or intermittently at specific intervals due to the high rotational speed of
the flywheel. Moving parts may also produce sounds that are amplified by the hollow metal tubes of the frame.
Additionally, it is common for the running noise to become slightly louder as you increase your training speed
and as the device components heat up and expand during your workout.
The cockpit does not show anything in the display when I turn it on
Check if the power cable is correctly attached to the device and properly plugged into the socket. Also, inspect
if there is any damage to the cable.
Examine the control cable to see if it has been pinched or jammed during assembly. Additionally, check if
the connector has come loose.
The pulse rate value is not shown or is indicated incorrectly
Please refer to the „Pulse & Heart Rate Monitoring” sections in this manual.
The hand pulse rate sensors are not functioning
Check if the hand sensor cables have been pinched or jammed during assembly.
The speed and distance values are indicated to be„0“during training
Check if the control cable has been pinched or jammed during assembly and/or if the connections have
come loose.
My training device makes creaking noises during training
Check if the training device is standing straight and flat on the ground. If not, re-adjust the foot stands. Also, check
whether the screws connecting the swing arms at the articulated joint to the pedal tubes are too tight.
My feet fall asleep during training
The reason for this is often tight training shoes. It is suggested to loosen the shoes as your feet will expand
during exertion. Seeking advice from sports shops or specialist running shoe shops is recommended.
FAQ
33
33

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Maxxus CX 5.1 and is the answer not in the manual?

Maxxus CX 5.1 Specifications

General IconGeneral
BrandMaxxus
ModelCX 5.1
CategoryFitness Equipment
LanguageEnglish

Related product manuals