MAINTENANCE
Light Replacement
Before replacing light bulb, disconnect power
to oven. Be sure bulb is etx)l. Do not touch a hot
bulb with a damp eloth as the bulb maybreak.
Use a dr)' pot bolder to prevent possibk harm to
hands. If bulb should break, use a pot bolder to
_)rotect bands and veO, carefully" remove bulb. If
ulb breaks at base, bare a service teehnieian
remove bulb.
Oven light bulb is located on back oven wall.
Replace with a 40 watt appliance bulb, Restore
power to oven. Reset clock.
Note for Self-Clean Ovens:
Remove 4 screws and plates as illustrated below.
Use care when removing gasket, it may tear.
Replace only with a 40 watt appliance bulb.
Reconnect power to oven and reset clock.
Removable Oven Door
To remove door:
1. Open door to the broil stop position (€_pen
about 4--6 inches).
2. Grasp the sides of the door at the middle of
the door. Slowly lift door straight up.
CAUTION:
Hinge arms are spring mounted and will slam
hut against the oven if aceidenta!ly hit. Never
]lace hand or fingers between the hinges
_nd the front oven frame. You could be
injured if hinge snaps back.
Do not attempt to open or close door until door
is completely seated on hinge arms. Never turn
on oven unless door is properly in place. When
baking, be sure door is completely closed.
Baking results will be affected if door is not
securely closed.
3. As you lift the dnnr up. yen" slightly open
door by pulling door toward y'ou. Check to be
sure latches swing do\_aa into the notdles un
the hinge arms.
To replace door:
1. Grasp sides of door and align slots in door with
hinge arms.
2. Very slightly pull door to a more open
position as you slide the door dowl_ onto the
hinge arms. The sliding acti]m of the door _I1
disengage the latches on the binge arms.
3. Gently push the door do_vnward until the dolor
rests evenly on the hinges. Close dcx_r.
f
PAGE 14 L
To Next Page
Loading...
Need help?
General
