2. Unscrew the hex-shaped regulator cap from the regulator and 4. Screw the hex-shaped regulator cap securely back into place.
remove the regulator pin. Do not overtighten.
A
To Convert Oven Bake/Broil Burner
1. Remove racks from inside the broiler cavity.
2. Screw the burner orifice hood away from the pins. There will
be approximately 11/2to 2 turns.
3=
B
A. Regu_rp_
B. Regu_rcap
Flip the regulator pin over and snap pin firmlyinto place.
A
A. LP gas position
B. Natural gas position
3=
A
A. Burner orifice hood
NOTE: On units using Eaton Oven Safety Valve, screw the
burner orifice hood away from the pin. There will be
approximately 11/2to 2 turns.
Adjust burner air shutter to the widest opening that will not
cause the flame to lift or blow off the burner when cold.
11
To Next Page
Loading...
