What to do if Maytronics MCC6 floats?
If your Maytronics Swimming Pool Vacuum floats instead of sitting on the pool floor, try removing the air again. Also, squeeze the combined brush/Wonder brush while the cleaner is in the water to ensure they are fully water absorbent.
How to remove kinks from Maytronics Swimming Pool Vacuum cable?
If the cable of your Maytronics Swimming Pool Vacuum has kinks, and you have an MCC6 model, push in the float on the non-cable side (see figure B). To remove the kinks, stretch the cable out completely and let it sit in the sun for at least a day.
Essential safety precautions and guidelines for operating the robotic pool cleaner safely and effectively.
Recommended water parameters and storage conditions for optimal performance and longevity of the cleaner.
Step-by-step instructions for initial preparation, including cable management and brush preparation.
Procedure for safely submerging the cleaner, ensuring proper air release and cable management.
Safe method for retrieving the cleaner from the pool using the handle, avoiding cable strain.
Detailed steps for detaching, cleaning, and reattaching the filter bag for optimal filtration.
Guide on how to properly fit and secure a new filter bag onto the cleaner's frame.
Instructions for cleaning the reusable filter cartridges to maintain effective debris capture.
Procedure to access and clear debris from the impeller for uninterrupted operation.
General| Weight | 24 lbs |
|---|---|
| Cleaning Cycle Time | 1, 1.5, 2, 2.5 hours |
| Filter Type | Multi-Layer Cartridge |
| Cable Length | 60 ft |
| Power Supply | 24V DC |
| Caddy | Yes |
| Type | Robotic |
| Pool Type | In-ground |
| Filtration | Ultra-Fine |
To Next Page