Black plate (403,1)
Low-beam bulbs
High-beam bulbs/Daytime running
lights
6. Install the new bulb in the reverse order
of the removal procedure.
Front turn signal lights/Parking lights
(Front side-marker lights)
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. If you are changing the right bulb, start
the engine, turn the steering wheel all
the way to the right, and turn off
engine. If you a re changing the left
bulb, turn the steering whee l to the left.
3. Pull the center of each plastic retainer
and remove the retainers.
Installation
Removal
4. Turn the screw counterclockwise and
remove it, and then partially peel back
the mudgu ard.
5. Turn the socket and bulb assembly
counterclockwise and remove it.
Maintenance and Care
Owner Maintenance
6-43
CX-5_8DR3-EC-14A_Edition3 Page403
Monday, June 30 2014 3:40 PM
Form No.8DR3-EC-14A
To Next Page
Loading...
