Mazda CX-5 - Page 125

CAUTION
l
Do not allow the intrusion sensor to
get soiled or wipe it with a liquid.
l
Do not shock or cause an impact to
the intrusion sensor or the intrusion
sensor bezel.
l
Do not install seats or seat covers
that are not Mazda genuine products.
l
To prevent obstruction of intrusion
sensor, do not place objects or cargo
near the intrusion sensor that are
higher than the head restraints.
Intrusion sensor and
intrusion sensor bezel
qOperation
Siren triggering conditions
The siren sounds intermittently and the
hazard warning lights flash for about 30
seconds when the system is triggered by
any one of the following:
l
Unlocking a door with the key or an
inside door-lock knob.
l
Forcing open a door, the bonnet or the
liftgate.
l
Opening the bonnet by operating the
bonnet release handle.
l
Switching the ignition ON without
using the push button start.
l
The intrusion sensor detects a
movement in the vehicle.
The system will be triggered again (up to
10 times) if one of the above conditions
remains.
l
Disconnecting the battery terminal (the
hazard warning lights do not flash).
The system will be triggered about 10
times.
NOTE
l
If the battery goes dead while the
theft-deterrent system is armed, the
siren will activate and the hazard
warning lights will flash when the
battery is charged or replaced.
l
The liftgate does not open while the
siren is sounding and the hazard
warning lights are flashing.
qHow to Arm the System
1. Close the windows and the sunroof
í
securely.
NOTE
Even with a window or the sunroof
í
open, the system can be armed,
however, leaving the windows and the
sunroof
í
even partially open can invite
theft, and wind blowing into the vehicle
could trigger the alarm.
The intrusion sensor function can also
be cancelled.
Refer to Cancelling the Intrusion Sensor
on page 3-50.
Before Driving
Security System
3-49
í
Some models.