2. Press the push button start off.
3. Make sure the bonnet, the doors, and
the liftgate are closed.
4. Press the lock button on the transmitter.
The hazard warning lights will flash
once.
(With the advanced keyless function)
Press a request switch.
The security indicator light in the
instrument panel flashes twice per
second for 20 seconds.
Refer to Warning/Indicator Lights on
page 4-33.
5. After 20 seconds, the system is fully
armed.
NOTE
l
The theft deterrent system can also
be armed by activating the auto
relock function with all the doors,
the liftgate and the bonnet closed.
Refer to Transmitter on page 3-4.
l
The system will disarm if one of the
following operations takes place
within 20 seconds after pressing the
lock button:
l
Unlocking a door.
l
Any door or the liftgate is opened.
l
The bonnet is opened.
l
The ignition is switched on.
To rearm the system, do the arming
procedure again.
l
When the doors are locked by
pressing the lock button on the
transmitter while the theft-deterrent
system is armed, the hazard warning
lights will flash once to indicate that
the system is armed.
qCancelling the Intrusion Sensor
If the theft deterrent system has been
armed while any of the following
conditions are present, cancel the
intrusion sensor to prevent the alarm from
triggering unnecessarily.
(Intrusion sensor)
l
Leaving the vehicle with a movab le
object, passengers or pets remaining
inside.
l
Leaving an object inside the vehicle
that can roll around, such as when the
vehicle is placed on a tilting, unstable
surface when being shipped.
3-50
Before Driving
Security System
To Next Page
Loading...
