NOTE
l
If the ignition is switched off while
the seat warmer is operating (High,
Mid or Low) and then switched ON
again, the seat warmer will
automatically operate at the
temperature set before switching off
the ignition.
l
Use the seat warmer when the engine
is running. Leaving the seat warmer
on for long periods with the engine
not running could cause the battery
power to be depleted.
l
The temperature of the seat warmer
cannot be adjusted beyond Hi gh,
Mid and Low because the seat
warmer is controlled by a thermostat.
qSeat Position Memory (Driver's
seat)
í
The seat position memory function allows
you to programme the driver's seat to a
desired seat position and to call up a
programmed posit ion with the simple
touch of a button.
CAUTION
Do not place fingers or hands around
the bottom of the seat while the seat
memory function is operating. The seat
moves automatically while the seat
memory function is operating and
fingers or hands could get pinched and
injured.
SET button
The seat position can be programmed or
operated using the follow ing operations.
l
Operation of the buttons on the side of
the seat.
l
Operation using the key.
NOTE
l
Individual seat positions can be
programmed to the two available
programming buttons on the side of
the driver's seat, plus one seat
position for each registered key.
l
If the vehicle has been serviced and
the battery leads disconnected, the
programmed seat positions will have
been erased. Re-programme the seat
positions.
Programming
1. Switch the ignition OFF.
2. Adjust the seat to the desired position
using the slide lifter and reclining
switches.
Refer to Seat Operatio n on page 2-5.
3. Press and hold the memory SET button
until a beep sound is heard.
2-8
Essential Safety Equipment
í
Some models.
Seats
To Next Page
Loading...
