4. Perform one of the following settings
within 5 seconds of completing step 3
above:
l
To programme memory button 1 or
2, press and hold the button until a
beep sound is heard.
l
To programme a key, press and hold
the key
switch until a beep sound
is heard.
Adjusting a programmed position
(Programming to a button on the seat
side)
1. While the vehicle is stopped, press the
programming button for the seat
position you want to call up (button 1
or 2).
2. A beep sound is heard when the seat
position adjustment is completed.
NOTE
l
If seat movement is not required,
only the beep sounds.
l
When the ignition is switched ON,
the seat position memory function
does not operate unless the selector
lever is in the P position (Automatic
transaxle) or the parking brake is
applied (Manual transaxle).
l
When the ignition is switched OFF,
the seat position memory function is
operable while the selector lever is in
a position other than P position
(Automatic trans axle) or the parking
brake is not applied (Manual
transaxle), however, if the ignition is
switched ON while the seat position
memory function is operating, the
operation is stopped.
NOTE
l
The seat position adjustment is
cancelled in the following cases:
l
Any of the seat adjustment
switches is operated.
l
The SET button is pressed.
l
Programming butt on 1 or 2 is
pressed.
l
The key lock switch or unlock
switch is operated.
l
The vehicle starts moving.
(When programming to the key)
1. Unlock the doors by pressing a request
switch or the key
switch.
2. After unlocking the doors, the seat
position adjustment begins within 40
seconds of opening the driver's door,
and a beep sounds when the operation
is finished.
NOTE
l
If there is no seat position
movement, a beep is not heard.
l
When the ignition is switched ON,
the seat position memory function
does not operate unless the selector
lever is in the P position (Automatic
transaxle) or the parking brake is
applied (Manual transaxle).
Essential Safety Equipment
Seats
2-9
To Next Page
Loading...
