NOTE
l
Under the following conditions, the radar sensors (rear) cannot detect target objects or
it may be difficult to detect them.
l
A vehicle is in the detection area at the rear in an adjacent drivin g lane but it does
not approach. The Blind Spot Monitoring (BSM) system determines the condition
based on radar detection data.
l
A vehicle is travelling alongside your vehicle at nearly the same speed for an
extended period of time.
l
Vehicles approaching in the opposite direction.
l
A vehicle in an adjacent driving lane is attempting to pass your vehicle.
l
A vehicle is in an adjacent lane on a road with extremely wide driving lanes. The
detection area of the radar sensors (rear) is set at the road width of expressways.
l
In the following cases, the activation of the Blind Spot Monitoring (BSM) warning
lights and the warning beep may not occur or they may be delayed.
l
A vehicle makes a lane ch ange from a driving lane two lanes over to an adjacent
lane.
l
Driving on steep slopes.
l
Crossing the summit of a hill or mountain pass.
l
The turning radius is small (making a sharp curve, turning at intersections).
l
When there is a difference in the height between your driving lane and the adjacent
lane.
l
Directly after pressing the Blind Spot Monitoring (BSM) switch and the system
becomes operable.
l
If the road width is extremel y narrow, vehicles two lanes over may be detected. The
detection area of the radar sensors (rear) is set according to the road width of
expressways.
When Driving
i-ACTIVSENSE
4-143
To Next Page
Loading...
