NOTE
l
The Blind Spot Monitoring (BSM) warning lights may turn on in reaction to
stationary objects on the road or the roadside such as guardrails, tunnels, sidewalls,
and parked vehicles.
Objects such as guardrails and concrete walls
running alongside the vehicle.
Places where the width between guardrails or
walls on each side of the vehicle narrows.
The walls at the entrance and exits of tunnels,
turnouts.
l
A Blind Spot Monitoring (BSM) warning light may flash or the warning beep may be
activated several times when making a turn at a city intersection.
l
Turn off the Blind Spot Monitoring (BSM) system while pulling a trailer or while an
accessory such as a bicycle carrier is installed to the rear of the vehicle. Otherwise, the
radar’s radio waves will be blocked causing the system to not operate normally.
l
In the following cases, it may be difficult to view the illumination/flashi ng of the
Blind Spot Monitoring (BSM) warning lights equipp ed on the door mirrors.
l
Snow or ice is adhering to the door mirrors.
l
The front door glass is fogged or covered in snow, frost or dirt.
l
The system switches to the Rear Cross Traffic Alert function when the shift lever
(manual transaxle) or the selector lever (automatic transaxle) is shifted to the reverse
(R) position.
Refer to Rear Cross Traffic Alert (RCTA) on page 4-153.
4-144
When Driving
i-ACTIVSENSE
To Next Page
Loading...
