Skipping Voice Guidance (for faster
operation)
Press and release the talk butt on.
Troubleshooting for Voice Recognition
If you do not understand an operation
method while in the voice recogni tion
mode, say “Tutorial” or “Help” .
Commands useable anytime during
voice recognition
“Go Back” and “Cancel” are commands
which can be used at anytime durin g
voice recognition.
Returning to previous operation
To return to the previous operation, say,
“Go Back” while in voice recognition
mode.
Cancel
To put the Bluetooth
®
Hands-Free system
in standby mode, say, “Cancel” while in
voice recognition mode.
To prevent a deterioratio n in the voice
recognition rate and voice quality, the
following points should be observed:
l
The voice recognition cannot be
performed while voice guidance or
the beep sound is operating. Wait
until the voice guidance or the beep
sound is finished before saying your
commands.
l
Phone related commands are available
only when your phone is connected via
Bluetooth
®
. Make sure your phone is
connected via Bluetooth
®
before you
operate phone related voice commands.
l
Music play commands, such as Play
Artist and Play Album can be used
only in USB audio mode.
l
Do not speak too slowly or loudly (no
loud voice).
l
Speak clearly, without pausing between
words or numbers.
l
Dialects or different wording other than
Hands-Free prompts cannot be
recognised by voice recogni tion. Speak
in the wording specified by the voice
commands.
l
It is not necessary to face the
microphone or approach it. Speak the
voice commands while maintaining a
safe driving position.
l
Close the windows and/or the sunroof
to reduce loud noises from outside the
vehicle, or turn down the airflow of the
air-conditioning system while
Bluetooth
®
Hands-Free is being used.
l
Make sure the vents are not directing
air up towards the microphone.
NOTE
If the voice recognition performance is
not satisfactory.
Refer to Troubleshooting on page
5-145.
5-112
Interior Features
Bluetooth®
To Next Page
Loading...
