qIf the tyre pressure monitoring
system warning light flashes
If the tyre pressure monitoring system has
a malfunction, the tyre pressure warning
light flashes for about 1 minute when the
ignition is switched ON and then
continues illuminating. Have your vehicle
checked by an expert repairer, we
recommend an Authorised Mazda
Repairer as soon as possible.
qIf the KEY indication/warning
light (red) is indicated
Type A
“Keyless System malfunction” is
displayed
This message is displayed if the advanced
keyless entry & push button start system
has a problem.
Contact an expert repairer, we recommend
an Authorised Mazda Repairer.
CAUTION
If the above message is indicated, or the
push button start indicator light (amber)
flashes, the engine may not start. If the
engine cannot be started, try starting it
using the emergency operation for
starting the engine, and have the vehicle
inspected at an expert repairer, we
recommend an Authorised Mazda
Repairer as soon as possible.
Refer to Emergency Operation for
Starting the Engine on pag e 4-10.
“Set Power to OFF” is displayed
This message is displayed when the
driver's door is opened without switching
the ignition off.
“Key not found” is displayed
This message is displayed when any of
the following operations is performed
with the key out of the operational range
or placed in areas inside the cabin where it
is difficult for the key to be detected.
l
The push button start is pressed with
the ignition switched off
l
The ignition is switched on
l
All doors are closed without switching
the ignition off
Type B
If any malfunction occurs in the keyless
entry system, it illuminates continuously.
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
7-41
To Next Page
Loading...
