BODY STRUCTURE [PANEL REPLACEMENT]
09-80B–48
8. Make a reinforcement panel using the material from the front pillar reinforcement.
9. Because the front pillar reinforcement cannot be welded to the existing parts from the inside of the panel, drill 3
plug weld holes at the locations indicated by (C) on the existing parts. Install the reinforcement and the existing
parts by plug welding from the outside, then butt weld the new and existing parts.
Caution
• Press fit the reinforcement panel and the body side material, and then plug weld them.
10. Install the front pillar reinforcement.
(C)3
FRONT PILLAR
REINFORCEMENT
110mm
{4.33in}
CUT-AND JOIN
LOCATION
L=60mm
{2.36in}
80mm
50mm
t=1.2mm
REINFORCEMENT
{1.97in}
{0.05in}
{3.15in}
acxuub00000151
3419-1U-06C(09-80B).fm 48 ページ ２００６年３月２４日 金曜日 午後４時４７分
To Next Page
Loading...
