Page 216 of 226
Version: 3.3.5 – DR05 – 23.03.2017
24. Factory settings on delivery
Username and password 24.1
The router is shipped with the following username and password:
Username: admin
Password: No password required
IP address of the router 24.2
The router is set to the following IP address in the factory:
IP address: 192.168.0.100
25. Loading the factory settings
Follow the steps outlined below to reset the industrial router to the factory settings:
IMPORTANT: You should first back up your configuration. Once you have carried out these steps, your
previous settings will no longer be available.
1. Switch on the device
2. Wait until the Rdy LED blinks
3. Press and hold the dial-out button until the Fc4 / TxD2 LED lights up
4. Press the dial-out button again (Fc3 / RxD2 lights up)
5. Press the dial-out button again (Fc2 / TxD1 lights up)
6. Finally press the dial-out button one last time
The custom configuration is then deleted, the industrial router is reset to the factory settings and
can be reconfigured.
IMPORTANT: The IP address of the industrial router is reset to 192.168.0.100. The computer’s network set-
tings must be changed accordingly.
To Next Page
Loading...
Need help?
General
