McCONNEL MULTIDRIVEM380‐4&M420‐4
82
FIRST 100 HOURS OF OPERATION
1. Check all oil levels regularly.
2. Tighten wheel and rim nuts regularly ESPECIALLY after changing wheels and
during first 20 hours of operation.
3. Do not over rev the engine when lightly loaded.
4. Do not allow the engine to idle at low speed for long periods.
5. Do not allow the engine to labour under heavy loads. Change down a gear if
necessary.
6. Ensure tyre pressures are correct for the task in hand and/or the load being carried.
Consult your tyre dealer for advice.
AFTER FIRST 100 HOURS
Component Description
Front Axle Differential Drain and refill with fresh oil
Front Axle Hubs Drain and refill with fresh oil
Rear Axle Differential Drain and refill with fresh oil
Rear Axle Hubs Drain and refill with fresh oil
Transmission Drain and refill with fresh oil
Transmission fine filter
Replace filter element - use only
genuine ZF filter
Batteries Check electrolyte level
Air System Drain moisture from tank(s)
Air Cleaner Remove primary element and clean
Hydraulic System
Renew hydraulic filter element. Check
system pressures. Check to ensure
that none of the hydraulic hoses are
chaffing, pay particular attention to
steering and brake hoses.
IT IS ESSENTIAL to ensure the hydraulic filter in the top of the hydraulic tank is changed.
This will ensure that any that any contamination in the hydraulic system is removed.
To Next Page
Loading...