McCulloch ROB S400 - Page 15

60- cm / 24- in.
• Put the charging station near a power outlet.
• Put the charging station on a level surface.
Max 5 cm/2"
Max 5 cm /2"
Max +/- 2 cm / 0.8 in.
• Put the charging station in the lower section
of the work area.
• Put the charging station in an area with
protection from the sun.
• If the charging station is installed on an
island, make sure to connect the guide wire
to the island. Refer to
To make an island on
page 17
.
3.4.2 To examine where to put the power
supply
WARNING: Do not cut or extend the
low-voltage cable. There is a risk of
electrical shock.
CAUTION: Make sure that the blades
on the product do not cut the low-
voltage cable.
CAUTION: Do not put the low-voltage
cable in a coil or below the charging
station plate. The coil causes
interference with the signal from the
charging station.
• Put the power supply in an area with a roof
and protection from the sun and rain.
• Put the power supply in an area with good
airflow.
• Use a residual-current device (RCD) when
you connect the power supply to the power
outlet.
Low-voltage cables of different lengths are
available as accessories.
1411 - 001 - 18.12.2019
Installation - 15