McIntosh MHA100

11
Connecting Components
"
;Q7<B=A6:/0=@/B=@G7<1
07<56/;B=<<G
;12##
A/1212 >:/G3@
6/<21@/4B327<CA/E7B6CA/<27;>=@B32>/@BA
Computer
Tune r
Disc Player
Left LoudspeakerRight Loudspeaker
Connect to
AC Outlet
3. Rotate the Output Terminal Post clockwise until it is
¿QJHUWLJKW5HIHUWR¿JXUH-7KHQXV-
ing the McIntosh Wrench, rotate the top
of the Output Terminal one quarter of a
WXUQDo not over tighten. Refer
WR¿JXUH(
4. Referring to figure K, connect the Loudspeaker
hookup cables with banana plugs
into the hole at the top of the
terminal to the MHA100 Negative
Output Terminal and Positive Out-
put Terminal to the Loudspeaker
Terminal Connections being careful to observe the
correct polarities.
Refer to “General Information” Note 7 on page 4
for additional information.
5. Connect the MHA100 power cord to an active AC
outlet.
Spade Lug or Wire Connections:
6. Connect the Loudspeaker hookup cables to the
MHA100 Negative Output Terminal and Positive
Output Terminal to the Loudspeaker Terminal
Connections being careful to observe the cor-
rect polarities. Insert the spade lug connector or
prepared section of the cable end into the terminal
side access hole, and tighten the terminal cap until
the cable is firmly
clamped into the
terminals so the lugs
or wire cannot slip
out. Refer to figures L
and M.
Refer to “General Information” Note 7 on page 4
for additional information.
7. Connect the MHA100 power cord to an active AC
outlet.
-
+
-
+
Figure J
Figure K
Figure L
Figure M