20
The Front Panel IR Sensor used for Remote Control
Operation can be disabled in the event there is a con-
flict with another McIntosh component located in the
same room as the MHA100. Refer to “General Infor-
mation, note 6” on page 4 for additional information.
Disable the Front Panel IR Sensor by performing the
following steps:
1. Press and hold the INPUT CONTROL until the
Front Panel Display indicates the Model, Firmware
Version and Serial Number. Then rotate the IN-
PUT CONTROL and select the Setup Menu item
“REMOTE CONTROL, Enabled”. Refer to figure
19.
2. Rotate the OUTPUT Control until the Front Panel-
Display indicates “REMOTE CONTROL, Dis-
abled”. Refer to figure 20.
3. To exit from the Setup Mode, press the INPUT
CONTROL and the Front Panel Display will revert
back to its normal display.
Setup, con’t
active. Then rotate the INPUT CONTROL until
the Setup Menu item “POWER MODE, Auto Off:
On” appears on the Front Panel Display. Refer to
figure 17.
2. Rotate the OUTPUT Control until “POWER
MODE, Auto Off: Off” appears on the Front
Panel Display. Refer to figure 18.
3. To exit from the Setup Mode, press the INPUT
CONTROL and the Front Panel Display will revert
back to its normal display.
Power Mode, con’t
Figure 17
POWER MODE
Auto Off: On
Figure 18
POWER MODE
Auto Off: Off
Remote Control
Figure 19
REMOTE CONTROL
Enabled
Figure 20
REMOTE CONTROL
Disabled
To Next Page
Loading...
