33
19. Using the Up or Down directional push-buttons,
select “P” as the first character of the new title.
20. Press the Right directional push-button to select the
second character position of the title.
21. Using the Up or Down directional push-buttons
to select “H” the second character of the title.
22. Select the two remaining characters “O” and “N” of
the title by using the directional push-buttons.
23. Press the SELECT/OK Push-button once and then
press the Down directional push-button.
24. Continue next to the SURR MODE Input Setting. If
you do not wish to perform SURR MODE Input Set-
ting at this time, proceed to the Video Power.
Surround Mode
By default, the MX135 will remember the last Surround
Mode Setting for each input. It is also possible to assign a
Default Surround Mode for each Input, so every time that
Input is selected the Surround Mode will be the default set-
ting instead of the last selected Surround Mode for the in-
put. Refer to figure 20.
25. Using the Up or Down directional Push-buttons,
select SURR MODE from the On-Screen Menu, fol-
lowed by pressing the Left or Right directional
Push-buttons to select the CINEMA 1 Surround
Mode for DVD2 Input instead of the default setting
of LAST.
26. Continue next to the VIDEO POWER Control. If
you do not wish to perform VIDEO POWER Con-
trol Adjustments at this time, proceed to the Compo-
nent Video Input.
Video Power
The MX135 has a VIDEO POWER CONTROL Jack and
its activation is controllable by selecting any one of the
Analog Audio/Video Inputs. By default all eleven Analog
Audio/Video Inputs have the VIDEO POWER feature set
to the ON Position. In the following example, the VIDEO
POWER Settting for the new DVD2 Input will be switched
Off.
27. Using the Up or Down directional push-buttons,
select SOURCE INPUT from the On-Screen Menu,
followed by pressing the Left or Right direc-
tional push-buttons to select the DVD2 Input Num-
ber 5.
28. Using the Up or Down directional push-buttons,
select VIDEO POWER on the On-Screen Menu, fol-
lowed by pressing the Left or Right directional
push-buttons to select OFF. Refer to figure 21 on
page 34.
29. If you do not wish to perform COMPONENT
VIDEO Input Adjustments at this time, proceed to
Video Converter Input.
Figure 20
SETUP, con’t
Figure 19
MENU: INPUT SETUP
SOURCE INPUT 1 - IR-PH/AUX
TITLE PHON
DIGITAL INPUT OPT C LK
ÆZONE A ANALOG INPUT PHON
SURR MODE LAST
VIDEO POWER ON
COMPONENT VIDEO NONE
VIDEO CONV. INPUT OFF
MAIN MENU
MENU: INPUT SETUP
SOURCE INPUT 5 - IR-TP2
TITLE DVD2
DIGITAL INPUT OPT C LK
ZONE A ANALOG INPUT RCA
ÆSURR MODE CINEMA 1
VIDEO POWER ON
COMPONENT VIDEO NONE
VIDEO CONV. INPUT OFF
MAIN MENU
To Next Page
Loading...
