McQuay RDT User Manual

IM-738 Page 87
Warranty Registration Form (continued)
VI. GAS & OIL BURNER CHECK, TEST & START
(Gas) = Information which applies to gas burners.
(Oil) = Information which applies to oil burners.
(Both) = Information which applies to both gas and oil burners.
Specifications:
For Gas = See Forced Draft Gas Burner Installation and Maintenance Bulletin.
For Oil = See Oil Fired Furnace Installation and Maintenance Bulletin.
A. (Both) – Furnace Model No. ________________________________________________________________
B. (Both) – Burner Model No. _______________ Serial No. _______________________________________
C. (Gas) – Type Firing:............ Single Stage Two Stage Modulation
D. (Oil) – Type Firing Start: ..... Full Fire Start Low Fire Start
E. (Gas) – Rated Firing Rate: _______________ MBH Input
F. (Oil) – Rated Firing Rate: ________________ GPH, #2 Fuel Oil
G. (Both) – Altitude: _______________________ Ft. Above Sea Level
H. Is there a circulating tank? ................................................................................................................................... Yes No
VII. GAS BURNER CHECK, TEST & START
A. Input: _________ CFH
B. Gas Pressure at Burner: Inches W.C. ________
C. CO
2
: _________ %
D. CO :__________ %
E. Pilot Flame Only:______ Microamps (steady at low fire)
F. Pilot Tap-Gas Pressure: Inches W.C. _____________
G. Motor Only/Burner: FLA ________ Running Amps______________
H. High Limit Control OK?......................................................................................................................................... Yes No
I. Flame Safeguard: Microamps ______________
J. Flame Failure Shutoff:____________ Seconds
K. Airswitch OK?....................................................................................................................................................... Yes No
L. High Gas Pressure Switch OK? ........................................................................................................................... Yes No
M. Low Gas Pressure Switch OK?............................................................................................................................ Yes No
N. Main Gas Valve Close-off OK?............................................................................................................................. Yes No
VIII. OIL BURNER CHECK, TEST & START
A. Nozzle(s): Type/Manufacturer__________ GPH _______ Angle ______ Pattern Manufacturer___________
B. Nozzle Pressure ________________ psi
C. CO
2
: ___________ %
D. Smoke Spot: Number ______
E. Running Amps____________ FLA___________
F. _____________________________________ Flame Safeguard: Microamps
G. High Limit Control OK?......................................................................................................................................... Yes No
H. Flame Failure Shutoff OK?................................................................................................................................... Yes No
I. Ignition Failure Check OK? .................................................................................................................................. Yes No
IX.
Have all electronic or electrical controls been checked, adjusted,
and tested for proper operation per the installation and maintenance bulletins?......................................................... Yes No
X. MAINTAINING MICROTECH CONTROL PARAMETER RECORDS —
After the unit has been checked, tested and started and the final control parameters (Menus 11 through 28) have been set, the control
parameter record in the back of IM 485, 486 or 487 should be photocopied and the final settings recorded. These records should be kept
on file and updated whenever changes to the control parameters are made. This will facilitate any required analysis and troubleshooting of
the system operation.
Signature: _______________________________________________________ Date of Start-up: ____________________________
RETURN COMPLETED FORM TO:
McQuay International Warranty Department, 13600 Industrial Park Boulevard, Minneapolis, MN 55441
Comments:
Please list any additional comments which could affect the operation of this unit; i.e., shipping damage,
failed components, adverse installation applications, etc., on a separate sheet and attach to this form.

McQuay RDT Specifications

General

Brand	McQuay
Model	RDT
Category	Air Handlers
Language	English