76 Product Manual WHR-2
1.05 DELIVERY AND HANDLING
A. Chillers shall be delivered to the job site completely assembled and charged with
refrigerant and oil by the manufacturer.
B. Comply with the manufacturers instructions for rigging and handling equipment.
1.04 WARRANTY
The equipment manufacturer’s warranty shall be for a period of one year from date of
equipment start up but not more than 18 months from shipment. The warranty shall cover
defective material and workmanship within the above period, excluding refrigerant.
PART 2--PRODUCTS
2.01 ACCEPTABLE MANUFACTURERS
A. McQuay International
B. (Approved Equal)
2.02 UNIT DESCRIPTION
Provide and install as shown on the plans factory assembled, factory charged, and factory
run tested water-cooled reciprocating compressor packaged chillers in the quantity
specified. Each chiller shall consist of multiple accessible-hermetic reciprocating
compressors, multi-circuit direct expansion evaporator, water-cooled condensers, control
system and all components necessary for safe and controlled unit operation.
2.03 DESIGN REQUIREMENTS
A. General: Provide a complete reciprocating packaged chiller as specified herein and
as shown on the drawings. The unit shall be in accordance with the standards
referenced in section 1.02 and any local codes in effect.
B. Performance: Refer to the schedule of performance on the drawings. Performance
shall be in accordance with applicable ARI Standard.
C. Acoustics: Sound pressure levels for the unit shall not exceed the following
specified levels. The manufacturer shall provide the necessary sound treatment
to meet these levels if required. Sound data shall be provided with the quotation.
Test shall be in accordance with ARI Standard 575.
Octave Band
63 125 250 500 1000 2000 4000 8000 dBA
____ ____ ____ ____ ____ ____ ____ ____ ____
To Next Page
Loading...
Need help?
General
